Audiolab Low Profile Tilt Mount for Flat Panel TVs
As TVs get thinner and lighter, maximum holding capacities decrease as a result. The Audiolab Tilt Mount for Flat Panel TVs has a slightly reduced weight rating, with the ultimate goal of going slimmer. But rest assured, we did not compromise on build quality. Pick one of these thin TV mounts up to feel the 2.5mm thick steel used to make them, and notice the post-installation leveling screws, built-on lockable tabs, and easy-to-use wall plate to help make your custom AV job that much easier.
Installation - Currently Audiolab X-Large tilt and fixed mounts include mounting bracket bolts in sizes up to M8 (8mm). Some 65"+ HDTVs require M10 mounting bracket bolts. Please check your HDTV's mounting holes prior to installation.
Underneath its beautiful black powder coat, the SM-T mount is 2.5mm (XL is 3mm) of solid steel. Flat panels are getting thinner and thinner, and so should mounts holding them.
With TV's getting ultra slim, it was time to trim some weight off our mounts. These mounts are only 2-¼" (XL is 2.63") deep for a low profile tilt mount.
Leveling a mount is fairly straightforward and rather simple – except when you face an unlevel mantle or just slightly sloped ceiling. We understand the pain of having to re-level an installed mount, so this mount include post-install leveling screws for last minute adjustments.
Our fixed and tilt mounts now include LokTight™ rotating lockable tabs directly on the arms themselves. The lockable tabs keep the arms against the mount, eliminate easy lifting from curious kids, and allow for a locking device to be added for security measures.
The center bolt hole location includes a notch so you can drill in a sheetrock screw for temporary hanging. Plus, it's reversible so there is no set top or bottom, which means no confusion. And, the wide mouth in the center allows for easy placement over a large Midi plate.
Lifetime Limited Warranty
Our mount products have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused, modified or disassembled. Products to be repaired under this warranty must be returned to Audiolab with prior notification and an assigned return authorization number (RA).